One offs and restoration sheet metal work. If you can dream it, we can make it!
Below are a selection of projects. Click on a thumbnail or scroll down. If available a link to a Gallery of additional photographs is included.
Hand Formed Air Filter
This injected 427 Cobra had no means of keeping the dirt out of the engine. An air filter had to be hand formed. With very little hood clearance, it was a challenge that worked out quite nicely.
When building late model hot rods a lot of the factory plastic body parts must be re-made in sheet metal to allow room for a larger tire, yet still appear stock.
BEFORE: Top photo shows the left rear fender of a 1923 Rolls Royce that was previously a New York City Limo. The fender had been damaged and given to the wrong shop to be repaired.
AFTER: The new fender was shrunk and hammered to match the body lines of the car, then welded back together. It was sanded and worked to find any minor high spots.
The passenger side rear fender (bottom photo foreground) was used as a mirror for the damaged fender and to insure the fenders lines were accurately reconstructed.
